The sleeves slide onto the roller frame and lock into place with a setscrew. |
|
If you have the type that slips over a copper nipple, use a hex key to loosen the setscrew on the underside to twist-pull the spout off. |
|
The barrel is held in place by a simple clamp and setscrew arrangement. |
|
The setscrew is manufactured in casehardened steel and is coated to protect against corrosion. |
|
When prompted by the software, unscrew the setscrew quite a bit and remove the partially milled block carefully from the milling unit. |
|
After noting the probe position in the bushing, slowly loosen the setscrew on the bushing and slide the probe out. |
|
The hubs must be axially secured on the shaft by means of a setscrew, an end plate or a sufficient interference. |
|
Place the door lever on the external spindle in such a way that the setscrew points in the direction of the locking plate. |
|
While holding the probe in place, tighten the setscrew just until the probe is held firmly in place. |
|
Loosen the setscrew just until the probe slides out of the bushing or the setscrew may fall out. |
|
They are 440 stainless steel, wide inner ring, setscrew locking inserts, with ss flingers over single-lip seals. |
|
To remove a block-off plug or flow control, loosen the setscrew on the bottom of the fluid manifold block and pull the block-off or flow control out of the manifold. |
|
Fasten the calibration phantom with the setscrew. |
|
The free end of this arm had a notch through which the movable fiber was threaded into the guide tube and secured in place by a setscrew. |
|
The insert is held in place by a tiny setscrew and can be easily replaced in case of damage or breakage. |
|
Tighten setscrew after adjusting the Actuator. |
|
The setscrew can easilybe adjusted to the desired stop height viathe slot. |
|
Retained to the slide by an Allen-head setscrew, the open square notch is. |
|
It is retained by a setscrew and should be readily adjustable for windage. |
|