| The tissue samples have been immersed into a cuvette with aqueous glucose or mannitol solution. |
|
| The irradiations were performed in a thermostated cylindrical glass cuvette fitted with a magnetic stirrer. |
|
| Irradiation at a low oxygen concentration was carried out in a tightly stoppered quartz cuvette purged with nitrogen. |
|
| A stir bar in the cuvette ensures uniform concentration of the solution during light exposure. |
|
| The cylindrical, polished glass cuvette was run under an ionizer to minimize unwanted light scatter and static charge before each experiment. |
|
| A paddle cuvette stirrer was placed in the quartz cuvette containing the liposome suspension. |
|
| These currents become progressively stronger when the depth of the liquid in the cuvette is increased. |
|
| Non-enzymatic reduction of DHA by reduced glutathione in phosphate buffers of different pHs was also measured in a separate cuvette at the same time. |
|
| If you measure cold samples, the outside of the cuvette may mist up after the sample is poured in causing the measured value to be much too high. |
|
| Otherwise, the outside of the cuvette may mist up after pouring in due to a cold sample, causing the measured value to be much too high. |
|
| Replace the cuvette immediately after the calibration to prevent accelerated saturation of the desiccant. |
|
| The arrow on the marker ring must point to the marker pin on the casing of the cuvette shaft. |
|
| Make sure that the outside of the cuvette is clean, dry, and free of fingerprints. |
|
| Finally, the sonicate in the third cuvette was additionally treated with DNase for another 1 h at 25 deg C, then Cyan 40 was added and the emission spectrum was recorded. |
|
| No contact between cuvette piezo and springs. |
|
| Unscrew the old cuvette and replace with a fresh clean one. |
|
| The most commonly affected location is in the pre or post cuvette tubing segments, entering or leaving the BVM module. |
|
| There is a green cylindrical piece of TPE to ensure a secure and consistent placement of the cuvette. |
|
| The cuvettes are square and are beveled on two sides so that there is no problem with aligning the cuvette correctly. |
|
| Automatic recognition of the used type of cuvette. |
|
|
|
| Use of 160 samples in each run meant that each of the cuvettes had been used once for each analyte and that cuvette rinsing was performed only once in between. |
|
| Where plenty of sample is available, this technology would not be used since the performance of conventional cuvette technology will always be better. |
|
| Cuvette temperature was controlled by a circulating water bath, and the contents were continuously agitated by a magnetic stirring bar. |
|
| This could potentially include the inland Cuvette Centrale basin, and the lakes in the eastern part of the country such as lakes Edward, Kivu, Tanganyika and Mweru. |
|
