We lengthened the forestay by another 2 or 3 turns and in a few minutes we were sailing again. |
|
Since the jib halyard attaches to the same place as the forestay, the load is pretty well transferred. |
|
To reduce normal weather helm loosen the backstay bottlescrew and tighten the forestay bottlescrew. |
|
By contrast, an inner forestay and staysail can be left in place, ready to go when you need them most. |
|
The bobstay, forestay and one running backstay were made up by my local chandler from the drawings below. |
|
The PROFURL motorised systems can be fitted on the existing forestay, with or without a turnbuckle cylinder. |
|
And in the last miles, the boat lost a forestay, a rigging wire which helps support the mast. |
|
Do not remove the lowest clevis pins which connect the forestay to the boat! |
|
Ensure that the jib halyard wire and line are not twisted around the forestay. |
|
The forestay tension is adjustable under sail thanks to a powerful block and tackle purchase. |
|
With an increasing load on the forestay, the masthead will want to move forward, with the risk of a negative bend. |
|
When adjusting forestay chainplate position, have your assistant walk forward and pull down with a trapeze wire for added security. |
|
Failure to observe what is happening in this situation may even result in damage to the forestay wire. |
|
One person now climbs the ladder on the crane until the forestay attachment can be reached. |
|
Insert the forestay adjuster into the furler drum one or two holes and pin in place. |
|
The backstay tension is adjusted using some form of tensioning device to control mast-bend and forestay tension. |
|
The rotation axis of the jib furler should run as far as possible in the prolongation of the forestay. |
|
Standard configuration: Seldén calculates the standard hand-tightened forestay length for a 1° aft rake. |
|
Centred and insulated forestay and completely insulated joining sleeves make furling easier, reduce wear and cut out the risk of corrosion. |
|
Runners are required to give sufficient longitudinal stability, and to obtain the required forestay tension. |
|
|
Check that the angle between the halyard and forestay is 5-10° when the sail is hoisted. |
|
Optional you can choose for a double forestay solution with extra Genoa. |
|
The stay running forward from a mast to the bow is called the forestay or headstay. |
|
Can I install a furling system on my existing forestay? |
|
Short wire pennants are not recommended as forestay forces may not be distributed evenly, and wire will not resist the torque which may be produced. |
|
Tack swivel with a free-turn, combined with the uniform profile of the forestay extrusion, give a perfectly furled sail and effective performance even when reefed. |
|